Select Cable: Removal

Set the vehicle on a lift.
Shift the select lever to "N" range.
Disconnect the ground cable from the battery.
Lift up the vehicle.
Remove the front, center and rear exhaust pipes and muffler. < Ref. to REMOVAL , Front Exhaust Pipe . > < Ref. to REMOVAL , Rear Exhaust Pipe . > < Ref. to REMOVAL , Muffler . >
Remove the heat shield cover.
Remove the snap pin and washer from range select lever.

Fig 1: Removing Snap Pin And Washer From Range Select Lever
Courtesy of SUBARU OF AMERICA, INC.
Remove the plate assembly from the transmission case.

Fig 2: Removing Plate Assembly From Transmission Case
Courtesy of SUBARU OF AMERICA, INC.
Disconnect the cable from arm assembly.

Fig 3: Disconnecting Cable From Arm Assembly
Courtesy of SUBARU OF AMERICA, INC.
Raise the pawl of clamp to remove the cable from bracket.

Fig 4: Identifying Claw
Courtesy of SUBARU OF AMERICA, INC.
Remove the select cable from plate assembly.