Knock Sensor: Installation

Install the knock sensor to the cylinder block.
NOTE: Extraction area of knock sensor cord must be positioned at a 60° angle relative to the engine rear.

Tightening torque:

24 N.m (2.4 kgf-m, 17.7 ft-lb)

Fig 1: Identifying Knock Sensor Cord Area
Courtesy of SUBARU OF AMERICA, INC.
Connect the knock sensor connector.

Fig 2: Identifying Knock Sensor Connector
Courtesy of SUBARU OF AMERICA, INC.
Install the air intake chamber.
Refer to INSTALLATION , Air Intake Chamber .
Connect the battery ground cable to battery.

Fig 3: Connecting Battery Ground Cable To Battery

Courtesy of SUBARU OF AMERICA, INC.