Fuel Sub Level Sensor: Installation

Install in the reverse order of removal while being careful of the following.

• Make sure the sealing portion is free from fuel or foreign matter before installation.
• Align protrusion (A) of the gasket to the position shown in the following figure.
• Align the protrusion (B) of fuel sub level sensor with the cutout on the upper plate of fuel sub level sensor.
• Tighten the nuts and bolts to the specified torque in the order as shown in the figure.
  NOTE: Use a new gasket and retainer.

  Tightening torque: 4.4 N.m (0.4 kgf-m, 3.2 ft-lb) 

  Fig 1: Identifying Upper Plate Of Fuel Sub Level Sensor Nuts Tighten Sequence

  Courtesy of SUBARU OF AMERICA, INC.
  Fig 2: Identifying Fuel Sub Level Sensor Bolts

  Courtesy of SUBARU OF AMERICA, INC.