LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2009 >> Tribeca Base >> Repair and Diagnosis (Single Page) >> Transmission >> Automatic Trans >> Automatic Transmission (5AT) (Diagnostics) >> Learning Control >> Procedure >> Preparation For Learning Control
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Preparation For Learning Control

  1. Warm-up or cool down until the ATF temperature displayed on the Subaru Select Monitor reaches 60 - 80°C (140 - 176°F).
  2. Shift the select lever to "P" range.
  3. Fully apply the parking brake.
  4. Lift up the vehicle.
    CAUTION: Be sure to keep the lowest edge of the tires 30 cm or more off the ground because the vehicle vibrates during the work.
  5. Connect the Subaru Select Monitor to the data link connector.
  6. Turn the ignition switch to ON. (Press push button ignition switch twice without depressing brake pedal for push button start.)
  7. Select {Learning and inspection mode related to AT} on the «Transmission Diagnosis» display screen of Subaru Select Monitor.
  8. Select {AT learning mode} on the «Learning and inspection mode related to AT» display screen of Subaru Select Monitor.
  9. Perform the procedures according to the message displayed on the Subaru Select Monitor.
scientia non olet · About LEMON Manuals