Simple Learning

NOTE: Simple learning is learning performed with the vehicle lifted, without actually running the vehicle.

CAUTION: Do not turn the power of the Subaru Select Monitor OFF during work, and do not disconnect the data link connector.

Follow the messages displayed on the Subaru Select Monitor screen when working.
NOTE: For the messages "SHIFT control system learning in progress" and "AWD control system learning in progress", AT OIL TEMP light in the combination meter blinks at a cycle of 2 Hz before learning operation starts. When AT OIL TEMP light in the combination meter goes off, the following message is displayed on the screen. When operation ends abnormally during the learning, AT OIL TEMP light blinks at a cycle of 4 Hz.

AT simple learning is complete when the message "AT learning normally ended" is displayed.

NOTE:

If a communication error occurs during learning, restart the «AT learning mode» over from the beginning.
If the message "Execute AT learning again after fixing troubles of the vehicle" appears, select [OK] and display the DTC list. After repairing the locations indicated by the DTC, start the "AT learning mode" over from the beginning.
If the message "AT learning ended abnormally" is displayed, start the "AT learning mode" over from the beginning.

MALFUNCTION CHART

Message	Main cause of abnormal incompletion
"AT learning ended abnormally"	A malfunction was detected during AT learning The accelerator pedal was pressed during AT learning An unspecified operation was performed during AT learning Brake pedal not stepped on firmly enough. Parking brake not applied strongly enough. Abnormal idle speed increase, etc.

For details concerning the operation procedure, refer to SUBARU SELECT MONITOR .