April 5, 2026: LEMON Manuals is launched! Read the announcement.

Select Cable: Removal

Set the vehicle on a lift.
Shift the select lever to "N" range.
Disconnect the ground cable from the battery.
Lift up the vehicle.
Remove the front, center and rear exhaust pipes and the muffler. (Non-turbo model)

Refer to REMOVAL , Front Exhaust Pipe. Refer to REMOVAL , Rear Exhaust Pipe. Refer to REMOVAL , Muffler.

Remove the center and rear exhaust pipes and the muffler. (Turbo model)

Refer to REMOVAL , Center Exhaust Pipe. Refer to REMOVAL , Rear Exhaust Pipe. Refer to REMOVAL , Muffler.

Remove the heat shield cover.

Fig 1: Identifying Heat Shield Cover

G05661183

Courtesy of SUBARU OF AMERICA, INC.

Remove the snap pin and washer from the shifter arm.

Fig 2: Identifying Snap Pin, Washer And Shifter Arm

G05955809

Courtesy of SUBARU OF AMERICA, INC.

Remove the plate assembly from the transmission case.

Fig 3: Identifying Plate Assembly And Select Cable

G05955810

Courtesy of SUBARU OF AMERICA, INC.

Disconnect the cable from arm assembly.

Fig 4: Identifying Adjusting Nut And Arm Assembly

G05955811

Courtesy of SUBARU OF AMERICA, INC.

Raise the claw of clamp to remove the cable from bracket.

Fig 5: Identifying Claw

G05955812

Courtesy of SUBARU OF AMERICA, INC.

Remove the select cable from plate assembly.