Select Cable: Installation

1. Install the select cable to plate assembly.

Tightening torque: 18 N.m (1.8 kgf-m, 13.3 ft-lb) 

Fig 1: Identifying Select Cable And Plate Assembly
Courtesy of SUBARU OF AMERICA, INC.
2. Install the select cable to the shifter arm.
3. Install the plate assembly to transmission.

Tightening torque: 

T: 25 N.m (2.5 kgf-m, 18.4 ft-lb) 

Fig 2: Identifying Plate Assembly And Select Cable
Courtesy of SUBARU OF AMERICA, INC.
4. Install the washer and snap pin to the shifter arm.
Fig 3: Identifying Washer And Snap Pin To Shifter Arm
Courtesy of SUBARU OF AMERICA, INC.
5. Install new clamp paying attention to the installing direction.
Fig 4: Identifying Clamp Installation Position
Courtesy of SUBARU OF AMERICA, INC.
6. Insert the tip of inner cable into connector hole of select lever, and fix the cable to bracket.
Fig 5: Fixing Cable To Bracket
Courtesy of SUBARU OF AMERICA, INC.
7. Shift the select lever to the "N" range, and adjust the select cable position. Refer to ADJUSTMENT , Select Cable.
8. Install the heat shield cover.
Fig 6: Identifying Heat Shield Cover
Courtesy of SUBARU OF AMERICA, INC.
9. Install the front, center and rear exhaust pipes, and the muffler. (Non-turbo model)

Refer to INSTALLATION , Front Exhaust Pipe. Refer to INSTALLATION , Rear Exhaust Pipe. Refer to INSTALLATION , Muffler.

10. Install the center, rear exhaust pipes and the muffler. (Turbo model)

Refer to INSTALLATION , Center Exhaust Pipe. Refer to INSTALLATION , Rear Exhaust Pipe. Refer to INSTALLATION , Muffler.