General Diagnostic Table: Inspection
SYMPTOMS CHART
| Symptoms | Possible cause | Corrective action |
|---|---|---|
| AT select lever | Starter does not run. | Adjust the select cable and inhibitor switch, or inspect the circuit. |
| Back-up light does not illuminate. | Adjust the select cable and inhibitor switch, or inspect the circuit. | |
| AT shift lock system does not operate normally. | Adjust the select cable and inhibitor switch, or inspect the circuit. | |
| Manual mode can not be set. | Adjust the mode switch and select lever, or inspect the circuit. | |
| Up-shift is not engaged at manual mode. | Check the shift-up switch and circuit. | |
| Down-shift is not engaged at manual mode. | Check the shift-down switch and circuit. | |
| MT gear shift lever (6MT) | Cannot shift into reverse. | Adjust the MT gear select cable. |
| Shifted to 6th though it shifted to reverse. | Adjust or replace the MT gear select cable. | |
| Can shift into reverse when the slider is not pulled up. | Adjust or replace the MT gear select cable. | |
| Slider cannot be pulled up or sticks in the pulled-up position. |
|