LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2010 >> Outback R >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Speed Control Systems (H4SO - 2.5L SOHC) >> Accelerator Pedal >> Inspection >> Check Accelerator Pedal Sensor Area (Method With Circuit Tester)
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Check Accelerator Pedal Sensor Area (Method With Circuit Tester)

  1. Remove the glove box lid assembly, glove box lower cover, instrument panel side cover RH and glove box back panel. Ref. to REMOVAL , Glove Box.
  2. Turn the ignition switch to ON. (engine OFF)
  3. Check the voltage between ECM connector terminals.
    Fig 1: Identifying Glove Box Lid Assembly
    G06648245Courtesy of SUBARU OF AMERICA, INC.

    Main sensor side

    Fig 2: Checking Voltage Between ECM Connector Terminals (Main Sensor Side)
    G06648606Courtesy of SUBARU OF AMERICA, INC.

    Sub sensor side

    Fig 3: Checking Voltage Between ECM Connector Terminals (Sub Sensor Side)
    G06648607Courtesy of SUBARU OF AMERICA, INC.

    (A) To ECM connector

    ACCELERATOR PEDAL SENSOR SPECIFICATION

    Accelerator pedal sensor Accelerator pedal Terminal No. Standard
    Main Not depressed (Full closed) 23 (+) and 29 (-) 0.4 - 1.0 V
    Depressed (Full opened) 2.4 - 3.7 V
    Sub Not depressed (Full closed) 31 (+) and 30(-) 0.3 - 1.1 V
    Depressed (Full opened) 2.3 - 3.8 V
  4. After inspection, install the related parts in the reverse order of removal.
scientia non olet · About LEMON Manuals