Steering Wheel: Removal

1. Disconnect the negative terminal from the battery, and wait for 60 seconds or more.
2. Set the tire to the straight-ahead position.
3. Remove the driver's airbag module assembly.

Preparation tool: TORX® T30 

1. Loosen the two TORX® bolts on the sides of the steering wheel.
   Fig 1: Locating Steering Wheel Torx® Bolts

   Courtesy of SUBARU OF AMERICA, INC.
2. Disconnect the airbag connector and remove the airbag module assembly. Refer to DRIVER'S AIRBAG MODULE, CURTAIN AIRBAG MODULE & PRETENSIONER Airbag Connector.
3. Disconnect the horn harness.
   Fig 2: Disconnecting Airbag Connector

   Courtesy of SUBARU OF AMERICA, INC.
4. Remove the steering wheel.
   CAUTION:

   • Always use the steering wheel puller for removal to avoid deforming the steering wheel.
   • If the steering wheel has been removed, make sure that the roll connector is not turned from the original position.
   1. Disconnect the connector and remove the nut.
   2. Put alignment marks and remove the steering wheel.
      Fig 3: Locating Marking On Steering Wheel

      Courtesy of SUBARU OF AMERICA, INC.