LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2011 >> Tribeca Limited >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission >> Front Vehicle Speed Sensor >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Front Vehicle Speed Sensor: Removal

  1. Remove the transmission assembly from vehicle body. Refer to REMOVAL , Automatic Transmission Assembly.
  2. Disconnect the rear vehicle speed sensor connector.
    NOTE: Secure the harness of the transmission harness to the transmission body using wire etc.
    Fig 1: Identifying Rear Vehicle Speed Sensor Connector
    G05668772Courtesy of SUBARU OF AMERICA, INC.
  3. Remove the extension case.
    Fig 2: Identifying Extension Case
    G05022239Courtesy of SUBARU OF AMERICA, INC.
  4. Remove the center differential carrier. Refer to REMOVAL , Center Differential Carrier.
  5. Lay along the transmission case, and then remove the oil pan.
  6. Remove the old gasket on the oil pan and transmission case completely.
  7. Disconnect the front vehicle speed sensor connector.
    Fig 3: Identifying Front Vehicle Speed Sensor Connector
    G05668774Courtesy of SUBARU OF AMERICA, INC.
  8. Remove the front vehicle speed sensor securing bolt.
    Fig 4: Identifying Front Vehicle Speed Sensor Securing Bolt
    G05022241Courtesy of SUBARU OF AMERICA, INC.
  9. Remove the front vehicle speed sensor through the hole of AT transmission main case.
scientia non olet · About LEMON Manuals