LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2011 >> Tribeca Limited >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission >> Transmission Control Device >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Transmission Control Device: Removal

  1. Remove the transmission assembly from vehicle body. Refer to REMOVAL , Automatic Transmission Assembly.
  2. Pull out the torque converter assembly. Refer to REMOVAL , Torque Converter Assembly.
  3. Lift up the lever on the rear side of transmission harness connector, and then disconnect it from the stay.
  4. Disconnect the air breather hose. Refer to REMOVAL , Air Breather Hose.
  5. Wrap vinyl tape around the nipple attached to the air breather hose.
  6. Remove the pitching stopper bracket.
  7. Remove the control valve body assembly. Refer to REMOVAL , Control Valve Body.
  8. Pull out the straight pin of manual plate.
    Fig 1: Identifying Straight Pin Of Manual Plate
    G05002847Courtesy of SUBARU OF AMERICA, INC.
  9. Remove the bolts securing range select lever, and then remove the select lever, manual plate and parking rod.
    NOTE: Be careful not to damage the lips of press-fitted oil seal in the case.
    Fig 2: Identifying Bolts Securing Range Select Lever, Manual Plate And Parking Rod
    G06343093Courtesy of SUBARU OF AMERICA, INC.
  10. Remove the detent spring.
    Fig 3: Identifying Detent Spring
    G05002849Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals