Idle Speed Control
CAUTION:
After executing the system operation check mode, execute the Clear Memory Mode. < refer to
OPERATION , Clear Memory Mode >
- On << System Operation Check Mode >> display, select {Idle Speed Control}.
- On << Start the Engine >> display, start the engine and click the [OK] button.
- In the << Idle Speed Control >> display, click the [A] button or the [V] button to change the setting values, then click the [OK] button.
Setting is possible in a range between 500 rpm - 2, 000 rpm, in increments of 50 rpm. However, the engine speed that can actually be controlled will vary depending on the vehicle.
- Click the [Cancel] button to stop the idle speed control.
- Click the [[F12] Exit] button to end the idle speed control. The screen will return to the << System Operation Check Mode >> screen.NOTE: For detailed operation procedures, refer to general scan tool operation manual.