Injector Control (Injection Quantity Control)
CAUTION:
After executing the system operation check mode, execute the Clear Memory Mode. < refer to
OPERATION , Clear Memory Mode >
- On << System Operation Check Mode >> display, select {Injector Control}.
- On << Injector Control >> display, select {Injection Quantity Control}.
- On << Start the Engine >> display, start the engine and click the [OK] button.
- In the << Injection Quantity Control >> display, click the ↑ button or the ↓ button to change the setting values, then click the [OK] button.
Setting is possible in a range between 0 - 20%, in increments of 1 %.
- Click the [Cancel] button to stop the injection quantity control.
- Click the [[F12] Exit] button to end the injection quantity control. The screen will return to the << Injector Control >> screen.NOTE: For detailed operation procedures, refer to application help for Subaru Select Monitor.