LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2012 >> Legacy Base, Automatic CVT Trans >> Repair and Diagnosis (Single Page) >> Transmission >> Automatic Trans >> Continuously Variable Transmission Diagnostics >> Learning Control >> Procedure >> Simple Learning
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Simple Learning

NOTE: Simple learning is performed with the vehicle lifted, without actually running the vehicle.
CAUTION: Do not turn the power of the Subaru Select Monitor to OFF or disconnect the data link connector during the operation.
  1. Select {AT related learning & inspecting mode} in the << Transmission Diagnosis >> screen of the Subaru Select Monitor.
  2. Select {AT learning mode} in the << AT related learning & inspecting mode >> screen of the Subaru Select Monitor.
  3. Follow the messages displayed on the Subaru Select Monitor screen when working.
    NOTE: During AT learning in progress, AT OIL TEMP light in the combination meter starts flashing at 2 Hz and the learning operation starts. The following message is displayed on the screen when the AT OIL TEMP light which was flashing at 2 Hz turns off.
  4. "AT learning normally ended." is displayed, simple AT learning is completed.
    NOTE:
    • If communication error occurs during learning, retry the "AT learning mode" from the beginning.
    • If the message "Execute AT learning again after fixing troubles of the vehicle" is displayed during learning, select [OK] to display the List of Diagnostics Trouble Code. After repairing the locations indicated by the DTC, start the "AT learning mode" over from the beginning.
    • When communication error occurs during learning, select lever does not shift occasionally. If select lever does not shift, turn the ignition to OFF and operate the lever.
    • If the message "AT learning ended abnormally." is displayed, start the "AT learning mode" over from the beginning.
      Message Primary cause of abnormal end
      AT learning ended abnormally.
      • Fault is detected during AT learning.
      • The accelerator pedal is depressed during AT learning.
      • Operation which is not directed is performed during AT learning.
      • ATF temperature becomes out of specification during AT learning.
      • Battery voltage is low.
      • Malfunction indicator light illuminates.
      • Electronic parking brake not applied strongly enough
      • Brake pedal not stepped on firmly enough.
      • Abnormal idle speed increase, etc.
    • For detailed operation procedures, refer to "PC application help for Subaru Select Monitor".
scientia non olet · About LEMON Manuals