LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2012 >> Outback Base, Automatic CVT Trans >> Repair and Diagnosis (Single Page) >> Transmission >> Automatic Trans >> Continuously Variable Transmission Diagnostics >> Learning Control >> Procedure >> Preparation For Learning
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Preparation For Learning

  1. Warm up or cool down until the ATF temperature displayed on the Subaru Select Monitor is 40 - 65°C (104 - 149°F).
  2. After stopping the vehicle, shift the select lever to "P" range.
  3. Apply the electronic parking brake.
  4. Lift up the vehicle.
    CAUTION: While working, be sure to keep the lower edge of the tires 30 cm or more above the ground as vehicle will vibrate.
  5. Connect the Subaru Select Monitor to data link connector.
  6. Turn the ignition switch to ON.
  7. Turn off all switches causing an electrical load, such as headlights, A/C, seat heater and rear defogger.
scientia non olet · About LEMON Manuals