Freeze Frame Data
NOTE:
- Data stored at the time of trouble occurrence is shown on display.
- Each time a trouble occurs, the latest information is stored in the freeze frame data in memory.
- If a freeze frame data is not properly stored in memory (due to a drop in VDCCM power supply, etc.), a DTC suffixed with a question mark "?" appears on the Subaru Select Monitor display. This shows it may be an unreliable reading.
| Display | Contents to be displayed |
|---|---|
| FR Wheel Speed | Wheel speed detected by front ABS wheel speed sensor RH is displayed in km/h or MPH. |
| FL Wheel Speed | Wheel speed detected by front ABS wheel speed sensor LH is displayed in km/h or MPH. |
| RR Wheel Speed | Wheel speed detected by rear ABS wheel speed sensor RH is displayed in km/h or MPH. |
| RL Wheel Speed | Wheel speed detected by rear ABS wheel speed sensor LH is displayed in km/h or MPH. |
| Vehicle Speed | Vehicle speed calculated by VDC control module is displayed. |
| Steering Angle Sensor Op | Steering angle detected by steering angle sensor is displayed. |
| Yaw Rate Sensor Output | Vehicle angular speed detected by yaw rate sensor is displayed. |
| Longitudinal G sensor output | Vehicle longitudinal acceleration detected by longitudinal G sensor is displayed. |
| Lateral G sensor Output | Vehicle lateral acceleration detected by lateral G sensor is displayed. |
| IG power supply voltage | Voltage supplied to VDC control module is displayed. |
| Accel. Opening Angle | Acceleration opening is displayed. |
| Engine Speed | Engine speed on malfunction occurrence is displayed. |
| Steering angle flag | Whether the absolute angle of the steering angle sensor was determined is displayed. |
| Display | Contents to be displayed |
|---|---|
| EBD Control Flag | EBD control condition is displayed. |
| ABS Control Flag | ABS control condition is displayed. |
| TCS Control Flag | TCS control condition is displayed. |
| VDC Control Flag | VDC control condition is displayed. |
| E/G Control Stop Flag | Engine control command signal is displayed. |
| OFF Switch Detection | ON/OFF condition of the VDC operated by the driver is displayed. |
| Brake Switch | Brake ON/OFF is displayed. |
| Master Cylinder Pressure Sensor | Master cylinder brake fluid pressure detected by pressure sensor is displayed. |
| FL Wheel Cylinder Pressure Sensor | 0 bar is always displayed. |
| FR Wheel Cylinder Pressure Sensor | 0 bar is always displayed. |