Throttle Sensor (Method With SUBARU Select Monitor)
NOTE:
- Individual difference of the accelerator pedal may not be corrected sufficiently on the ECM side after DTCs were cleared or the battery was removed and installed on the vehicle. Therefore, using the Subaru Select Monitor, check that the accelerator opening angle signal indicates 100%, when the accelerator pedal is fully depressed, and then perform the inspection.
- If the accelerator opening angle signal does not indicate 100%, check the accelerator pedal. Refer to INSPECTION .
- Warm up the engine.
- Turn the ignition switch to ON. (engine OFF)
- Read the throttle opening angle signal and voltage of throttle sensor using Subaru Select Monitor. Refer to READ CURRENT DATA FOR ENGINE (NORMAL MODE)
.
Throttle sensor Throttle opening angle signal Standard Main 5% Approx. 0.9 V Sub 5% Approx. 1.7 V - Start the engine.
- Read the throttle opening angle signal and voltage of throttle sensor using Subaru Select Monitor. Refer to READ CURRENT DATA FOR ENGINE (NORMAL MODE)
.CAUTION: When depressing the accelerator pedal to fully open, perform it in a short time as possible, but within the range where the inspection result is not adversely affected.NOTE: Perform the inspection in the following conditions.
- For AT model or CVT model: Select lever is in "P" range.
- For MT model: Gear shift lever is in the netural position.
- Parking brake activated