Rear Finisher Light Assembly: Removal

WARNING: This page is about a different car, the 2011 Subaru Tribeca. However, it is still accessible from the selected car via links, so may be relevant.

Remove the bulb inspection cover (A) of the rear gate trim.

Fig 1: Identifying Rear Finisher Light Bulb
Courtesy of SUBARU OF AMERICA, INC.
Disconnect the harness connector.
Remove the mounting nuts and detach the rear finisher assembly.

Fig 2: Locating Rear Finisher Assembly Mounting Nuts
Courtesy of SUBARU OF AMERICA, INC.