Rear Axle: Installation

WARNING: This page is about a different car, the 2011 Subaru Tribeca. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Be sure to use a new self-locking nut.
Always tighten bushings with wheels in full contact with the ground and the vehicle at curb weight.

Install in the reverse order of removal.
Tightening torque:

Refer to "COMPONENT" of "General Description" for the tightening torque.

Refer to COMPONENT , General Description.

Refer to COMPONENT COMPONENT , General Description.

Refer to COMPONENT , General Description.

Refer to COMPONENT , General Description.

Refer to COMPONENT , General Description.
Inspect the wheel alignment and adjust if necessary.