LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2012 >> Outback Base, Standard Trans >> Repair and Diagnosis >> General Information >> Reset Procedures >> Tire Pressure Monitor Systems >> TPMS Reset Procedures >> Tire Pressure Sensor Registration
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Tire Pressure Sensor Registration

NOTE: In the following procedure, the Subaru Select Monitor and Transmitter Registration Tool (TPM-00012 or Kent-Moore Part No. FJ45295) must be used.
NOTE: If the ignition switch and power supply of Subaru Select Monitor are turned off or the registration procedure is not performed within 5 minutes, registration mode is cancelled.
NOTE: If tires were rotated, the performance and function of TPM system is not affected. However, tire positions are not displayed in the Subaru Select Monitor correctly. Register transmitter IDs after rotation if correct display of tire sensor positions is required.
NOTE: If registration procedure is not successful after 2 attempts, replace TPM control module.
  1. Set the tire pressure of all wheels to specification.
  2. Connect Subaru Select Monitor.
  3. On "MAIN MENU" screen, select "EACH SYSTEM CHECK" and press YES (or OK) key.
  4. On "SYSTEM SELECTION MENU" screen, select "TIRE PRESSURE MONITORING" and press YES (or OK) key.
  5. Press YES (or OK) key after "TIRE PRESSURE MONITORING" is displayed.
  6. On the "TIRE PRESSURE MONITOR DIAGNOSIS" screen, select "TRANSMITTER ID REGIST CONFIRM" and press YES (or OK) key.
  7. When "ID REGISTRATION MODE EXECUTE, REGISTERED ID IS DELETED PROCEED?" is displayed, press YES (or OK) key.
  8. Using Transmitter Registration Tool (TPM-00012 or Kent-Moore Part No. FJ45295), contact sidewall near air valve of front left tire and press the switch to send transmitter ID to TPM control module (at this time, tire pressure warning light blinks to start registration procedure). Register tire pressure sensors, while noting the following:
    • Register transmitters in the following order: left front, right front, right rear, then left rear.
    • Transmitter registration tool should be in contact with sidewall near transmitter.
    • After registration for each tire completes, hazard light will blink and "ID REGISTRATION COMPLETED" will be displayed.
    • If registration procedure is stopped before completion (turning ignition switch to OFF position, wrong registration order, etc.), repeat procedure from step  6.
  9. After ID registration is completed, tire pressure warning light will turn on for 2 seconds.
  10. Check the registered transmitter IDs. See DISPLAY TRANSMITTER IDs . After all IDs are confirmed, drive vehicle at 25 mph (40 km/h) for 10 minutes.
scientia non olet · About LEMON Manuals