Interior Light System
Interior Light SystemINSPECTION
1. CHECK DOOR SWITCH.
1. Remove the door switch.
2. Measure the resistance between door switch terminals.
Preparation tool: Circuit tester
3. Replace the door switch if the inspection result is not within the standard value.
2. CHECK REAR GATE LATCH SWITCH
1. Disconnect the rear gate latch switch connector.
2. Measure the resistance between rear gate latch switch terminals.
Preparation tool: Circuit tester
3. If the inspection result is not within the standard value, replace the rear gate latch and actuator assembly.
3. CHECK TRUNK LID LATCH SWITCH
1. Disconnect the trunk lid latch switch connector.
2. Measure the resistance between trunk lid latch switch terminals.
Preparation tool: Circuit tester
3. If the inspection result is not within the standard value, replace the trunk lid latch and actuator assembly.