Parameter Selection

CAUTION:

NOTE:

When the VDCCM & H/U is replaced with a replacement part, be sure to perform the parameter selection/registration to the VDCCM & H/U using this function.
To confirm the applied model, refer to the MODEL NUMBER PLATE attached on the vehicle. .
When the applied model is entered wrong, re-entry is possible.
When the registration has not been performed, the DTC code "Parameter selection error" is detected together with the ABS/EBD/VDC warning light illumination.

Connect the Subaru Select Monitor.
On << Main Menu >> display, select {Each System Check}.
On << System Selection Menu >> display, select {Brake Control System}.
When {VDC} is displayed, select the [OK] button.
On << Brake Control Diagnosis >> display, select {Select Parameter}.
Check the applied model and option code indicated in the "Model number plate". Refer to MODEL NUMBER PLATE .
Enter the applied model of 7-digit alphanumeric characters and press the [Enter] key.
When the option code input screen appears after entering the applied model, enter the option code consisting of 4-digit alphanumeric characters, and press the [Enter] key When the option code is 3 digits, add "0" in front and enter the code as 4 digits.
When the confirmation screen indicating the vehicle information appears, check that the correct applied model and grade are displayed and click the [OK] button.
NOTE: When the displayed applied model and grade are different from those of the vehicle, perform registration operations again after clicking the [OK] button.
Execute the Clear Memory Mode after parameter selection and registration operations because the DTC for "Parameter selection error" is memorized. Refer to , CLEAR MEMORY MODE .