Intake Manifold: Assembly

Liquid gasket: 

THREE BOND 1105 (Part No. 004403010) or equivalent 

Tightening torque: 

17 N.m (1.7 kgf-m, 12.5 ft-lb) 

1. Install the purge control solenoid valve. Refer to PURGE CONTROL SOLENOID VALVE .
2. Install the manifold absolute pressure sensor. Refer to , INSTALLATION , Manifold Absolute Pressure Sensor.
3. Install the EGR valve. Refer to , INSTALLATION , EGR Valve.
4. Install the fuel pipe assembly.

   Tightening torque: 

   6.4 N.m (0.7 kgf-m, 4.7 ft-lb) 

   Fig 1: Locating Fuel Pipe Assembly Nuts (1 Of 2)

   Courtesy of SUBARU OF AMERICA, INC.
   Fig 2: Locating Fuel Pipe Assembly Nuts (2 Of 2)

   Courtesy of SUBARU OF AMERICA, INC.
5. Install the fuel injector pipe and hose.

   Tightening torque: 

   1.25 N.m (0.1 kgf-m, 0.9 ft-lb) 

   Fig 3: Locating Fuel Injector Pipe And Hose Clamp Bolts (LH Side)

   Courtesy of SUBARU OF AMERICA, INC.
   Fig 4: Locating Fuel Injector Pipe And Hose Clamp Bolts (RH Side)

   Courtesy of SUBARU OF AMERICA, INC.
6. Install the engine harness to the intake manifold. Refer to , ENGINE HARNESS , COMPONENT, General Description.