Camshaft Position Sensor (Method With Oscilloscope)

Prepare an oscilloscope.
Remove the glove box lower cover. < Refer to REMOVAL , Glove Box. >
Remove the lower inner trim of passenger's side. < Refer to REMOVAL , Lower Inner Trim. >
Turn over the floor mat of passenger's seat.
Remove the protect cover.

Fig 1: Locating Protect Cover Screws
Courtesy of SUBARU OF AMERICA, INC.
Remove the nuts and bolts which hold the ECM to the bracket.

Fig 2: Locating ECM Mounting Nuts And Bolts
Courtesy of SUBARU OF AMERICA, INC.

Connect the probe to ECM connector.

Fig 3: Connecting Probe To ECM Connector Terminals

Courtesy of SUBARU OF AMERICA, INC.

Start the engine and let it idle.
Check the pattern is the same as the waveform and voltage shown below.

Fig 4: Camshaft Position Sensor Output Waveform
Courtesy of SUBARU OF AMERICA, INC.
After inspection, install the related parts in the reverse order of removal.
Tightening torque:

7.5 N.m (0.8 kgf-m, 5.5 ft-lb)