LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2013 >> Outback Base, Automatic CVT Trans >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls (Diagnostics) (H4DO) >> Drive Cycle >> Procedure >> Drive Cycle H >> Diagnostic procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Diagnostic procedure

  1. Perform the Clear Memory Mode. Refer to CLEAR MEMORY MODE .
  2. With the ignition switch ON (engine stopped), read the value in «Coolant Temp.» and «Intake Air Temp.». Refer to DISPLAY CURRENT ENGINE DATA .
  3. If the values from step  2) satisfy the following conditions, idle the engine for one minute.

    Condition: 

    |Engine coolant temperature - Intake air temperature| ≤ 5°C (9°F) 

    NOTE:
    • If the conditions are not satisfied, turn the ignition switch to OFF and wait until the parameters are satisfied.
    • For CVT models, hold the select lever to "P" range or "N" range at idling, and for MT models, the shift lever in the neutral position at idling.
  4. Read the temporary code using the Subaru Select Monitor or general scan tool. Refer to OPERATION .
scientia non olet · About LEMON Manuals