LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2013 >> Outback Base, Standard Trans >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls (Diagnostics) (H4DO) >> Inspection Mode >> Procedure >> SUBARU Select Monitor
April 5, 2026: LEMON Manuals is launched! Read the announcement.

SUBARU Select Monitor

  1. Perform the Clear Memory Mode. Refer to CLEAR MEMORY MODE .
  2. Read the diagnostic trouble code (DTC) and check that no DTC is displayed. Refer to READ DIAGNOSTIC TROUBLE CODE (DTC) .
    NOTE: If the DTC is displayed on the screen, the trouble is still present. Perform the diagnosis using "Diagnostic Procedure with Diagnostic Trouble Code (DTC)". Refer to DIAGNOSTIC PROCEDURE WITH DIAGNOSTIC TROUBLE CODE (DTC) . After solving the DTC, repeat from step  1).
  3. Start the engine, and run the engine at idle for 10 seconds or more.
  4. Read the diagnostic trouble code (DTC) and check the DTC. Refer to READ DIAGNOSTIC TROUBLE CODE (DTC) .
    NOTE: If the DTC is displayed on the screen, the trouble is still present. Perform the diagnosis using "Diagnostic Procedure with Diagnostic Trouble Code (DTC)". Refer to DIAGNOSTIC PROCEDURE WITH DIAGNOSTIC TROUBLE CODE (DTC) . After solving the DTC, repeat from step  1).
scientia non olet · About LEMON Manuals