Inner Belt ASSY

CAUTION:

Before installation, make sure that the correct part is used.
During installation, make sure that the seat belts are not twisted.
Check that there is no pinching of the seat belt harness. Wrong harness rooting may cause the harness short from pinch.

Install the inner belt assembly.
Tightening torque:

Front seat belt: < Refer to FRONT SEAT BELT , COMPONENT, General Description. >
Locate the seat belt harness and retain it with a harness clip.

Fig 1: Locating Seat Belt Harness And Inner Belt Assembly Bolt
Courtesy of SUBARU OF AMERICA, INC.
Install the seat assembly to the body.
CAUTION:
- The seat mounting bolts differ between the front mounting points and the rear mounting points. Make sure that you are using correct bolts at correct positions.
- Tighten the slide rail installing bolts in the order as shown in the figure, in several steps by gradually increasing the torque until they reach the specified torque.
  
  Fig 2: Slide Rail Installing Bolts Tightening Sequence
  Courtesy of SUBARU OF AMERICA, INC.
- Front (bolt A): Washer diameter 22 mm (0.87 in)
- Rear (bolt B): Washer diameter 26 mm (1.02 in)
Tightening torque:

Front seat assembly: 53 N.m (5.40 kgf-m, 39.1 ft-lb)
Check that no harness is caught by sliding the seat back and forth.