Steering Column: Installation
- Install the grommet to the toe board.
- Insert the end of the steering shaft into the toe board grommet.
- Tighten the steering column installation bolt located under the instrument panel with the tilt lever fixed.
Tightening torque:
20 N.m (2.04 kgf-m, 14.8 ft-lb)
- Connect all the connectors under the instrument panel.
- Connect the airbag system connector.
- Install the instrument panel lower cover.
- Install the universal joint. < Refer to
INSTALLATION , Universal Joint. >CAUTION:
- Always install the universal joint after installing the steering column to avoid damage to the universal joint.
- Be sure to follow the tightening order and tightening torque of universal joint to avoid the steering effort from becoming heavy.
- Align the center position of the roll connector. < Refer to ADJUSTMENT , Roll Connector. >
- Install the steering wheel. < Refer to INSTALLATION , Steering Wheel. >