Select Cable: Installation

Install the select cable to plate assembly.
Tightening torque:

T: 18 N.m (1.8 kgf-m, 13.3 ft-lb)

Fig 1: Plate Assembly Select Cable With Torque Specifications
Courtesy of SUBARU OF AMERICA, INC.
Install the select cable to range select lever.
Install the plate assembly to transmission.
Tightening torque:

T: 25 N.m (2.5 kgf-m, 18.4 ft-lb)
- CVT model
  
  Fig 2: Select Cable And Plate Assembly With Torque Specifications (CVT Model)
  Courtesy of SUBARU OF AMERICA, INC.
- AT model
  
  Fig 3: Select Cable And Plate Assembly With Torque Specifications (AT Model)
  Courtesy of SUBARU OF AMERICA, INC.
Install the washer and snap pin to the shifter arm.
- CVT model
  
  Fig 4: Identifying Shifter Arm, Snap Pin, Select Cable, Plate Assembly And Washer (CVT Model)
  Courtesy of SUBARU OF AMERICA, INC.
- AT model
  
  Fig 5: Identifying Shifter Arm, Snap Pin, Select Cable, Plate Assembly And Washer (AT Model)
  Courtesy of SUBARU OF AMERICA, INC.
Install new clamp paying attention to the installing direction.

Fig 6: Installing Clamp
Courtesy of SUBARU OF AMERICA, INC.
Insert the tip of inner cable into connector hole of select lever, and fix the cable to bracket.

Fig 7: Inserting Tip Of Inner Cable Into Connector Hole Of Select Lever
Courtesy of SUBARU OF AMERICA, INC.
Shift the select lever to the "N" range, and then adjust the select cable position. Refer to ADJUSTMENT .
Install the heat shield cover.
Tightening torque:

18 N.m (1.8 kgf-m, 13.3 ft-lb)

Fig 8: Identifying Heat Shield Cover
Courtesy of SUBARU OF AMERICA, INC.
Install the front exhaust pipe and rear exhaust pipe.
- 2.5 L model
  Refer to INSTALLATION , Front Exhaust Pipe. and INSTALLATION , Rear Exhaust Pipe.
- 3.6 L model
  Refer to INSTALLATION , Front Exhaust Pipe. and INSTALLATION , Rear Exhaust Pipe.