LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2013 >> Outback R >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Fuel Injection System (H6DO) >> Fuel Injector >> Removal >> LH Side
April 5, 2026: LEMON Manuals is launched! Read the announcement.

LH Side

  1. Remove the collector cover.
    NOTE: Follow the steps below when removing the collector cover.
    1. Pull up the two points at the rear (A).
    2. Pull up the two points at the front (B) while moving them forward.
      Fig 1: Removing Collector Cover
      G06651504Courtesy of SUBARU OF AMERICA, INC.
  2. Release the fuel pressure. Refer to RELEASING OF FUEL PRESSURE .
  3. Remove the battery and battery carrier. Refer to REMOVAL .
  4. Open the fuel filler lid and remove the fuel filler cap.
  5. Remove the securing clips from the two locations on the fuel pipe protector LH.
    Fig 2: Locating Fuel Pipe Protector LH Mounting Clips
    G06651188Courtesy of SUBARU OF AMERICA, INC.
  6. Disconnect the PCV hose.
    Fig 3: Locating PCV Hose
    G08543852Courtesy of SUBARU OF AMERICA, INC.
  7. Remove the fuel pipe protector LH.
    Fig 4: Locating Fuel Pipe Protector LH Mounting Bolts
    G07912256Courtesy of SUBARU OF AMERICA, INC.
  8. Disconnect the connector from fuel injector.
  9. Remove the bolt which holds fuel injector pipe onto cylinder head.
    Fig 5: Locating Fuel Injector Pipe LH To Cylinder Head Mounting Bolts
    G07912258Courtesy of SUBARU OF AMERICA, INC.
  10. Remove the fuel injector while lifting up the fuel injector pipe.