LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2013 >> Outback R >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Fuel Injection System (H6DO) >> Fuel Injector >> Removal >> RH Side
April 5, 2026: LEMON Manuals is launched! Read the announcement.

RH Side

  1. Remove the collector cover.
    NOTE: Follow the steps below when removing the collector cover.
    1. Pull up the two points at the rear (A).
    2. Pull up the two points at the front (B) while moving them forward.
      Fig 1: Removing Collector Cover
      G06651504Courtesy of SUBARU OF AMERICA, INC.
  2. Release the fuel pressure. Refer to RELEASING OF FUEL PRESSURE .
  3. Disconnect the ground cable from battery.
  4. Open the fuel filler lid and remove the fuel filler cap.
  5. Loosen the clamp (A) which connects the air intake boot assembly.
  6. Loosen the bolt (B) which secures the air intake boot assembly to the collector cover bracket.
    Fig 2: Identifying Air Intake Boot Assembly Clamp And Bolt
    G08580897Courtesy of SUBARU OF AMERICA, INC.
  7. Remove the air intake boot assembly, and move it to the left side wheel apron.
    Fig 3: Identifying Air Intake Boot Assembly
    G08580898Courtesy of SUBARU OF AMERICA, INC.
  8. Remove the air cleaner case. Refer to REMOVAL .
  9. Remove the fuel pipe protector RH.
    Fig 4: Locating Fuel Pipe Protector RH Mounting Bolts
    G07912260Courtesy of SUBARU OF AMERICA, INC.
  10. Disconnect the connector from fuel injector.
  11. Remove the bolt which holds fuel injector pipe onto cylinder head.
    Fig 5: Locating Fuel Injector Pipe RH To Cylinder Head Mounting Bolts
    G07912261Courtesy of SUBARU OF AMERICA, INC.
  12. Remove the fuel injector while lifting up the fuel injector pipe.
scientia non olet · About LEMON Manuals