- Check that no DTC remains after clearing memory. Refer to
MODE $04 (CLEAR/RESET EMISSION-RELATED DIAGNOSTIC INFORMATION) .
- Warm up the engine.
- Install the delivery (test) mode fuse (A).
CAUTION:
Do not use any fuses that are installed on the vehicle.
Courtesy of SUBARU OF AMERICA, INC.
- Connect the general scan tool to data link connector located in the lower portion of the instrument panel (on the driver's side).
CAUTION:
Do not connect the scan tools except for Subaru Select Monitor and general scan tool.
Courtesy of SUBARU OF AMERICA, INC.
- Start the engine.
NOTE:
Ensure the selector lever is placed in the "P" range before starting.
- Turn the neutral position switch to ON using select lever.
- Depress the brake pedal to turn the brake switch ON.
- Keep the engine speed in 2, 500 - 3, 000 rpm range for 40 seconds.
- Shift the select lever in the "D" range and drive the vehicle at 5 to 10 km/h (3 to 6 MPH).
NOTE:
- For AWD model, release the parking brake.
- The rotating speed difference between front and rear wheels may illuminate the ABS warning light, but this does not indicate a malfunction. When engine control system diagnosis is finished, perform the VDC memory clearance procedure of self-diagnosis function. Refer to
CLEAR MEMORY MODE
.
- Using the general scan tool, check for DTC and record the result(s).