Mt Shift Control

1. Check for smooth operation to each position. Especially, shifting to 5th ↔ 6th, and then to Rev, check for any drag.
2. Check the slider returns to the original position by shifting to the Rev and then back in neutral while pulling up the slider.
3. If the shifting operation is not smooth, readjustment the exposed length (a) of MT gear select cable following the figure.
   Fig 1: Identifying MT Shift Control Of Exposed Length

   Courtesy of SUBARU OF AMERICA, INC.

• If the shift cannot be inserted to push the reverse lock bracket 5th and 6th.

  → Extend the exposed length (a) of MT gear select cable.

• When operate the select lever to 4th → 5th, it cannot be operated at select lever crank line.

→ Shorten the exposed length (a) of MT gear select cable.