Security System (Alarm System)

NOTE: The following inspections show the initial settings. When the settings are different from the initial settings, use Subaru Select Monitor to check the details of each setting for inspections. Refer to OPERATION .

Fully open all the door windows.
Remove the key from the ignition switch and close all the doors including rear gate.
Press the "LOCK" button momentarily on the keyless transmitter. All doors are locked, and the security indicator light blinks faster (five times per two seconds) for 30 seconds and goes slower (twice per two seconds), then the alarm system is in set condition.

Fig 1: Pressing LOCK Button On Keyless Transmitter
Courtesy of SUBARU OF AMERICA, INC.
Press the "UNLOCK" button momentarily on the keyless transmitter. When the door of the driver's seat is unlocked, the security indicator light operates (flashes once in three seconds), and the alarm system enters the release mode.

Fig 2: Pressing UNLOCK Button On Keyless Transmitter
Courtesy of SUBARU OF AMERICA, INC.
Close all the doors including rear gate. Press the "LOCK" button momentarily on the keyless transmitter. All doors are locked and the alarm system is in set condition after 30 seconds.
Unlock the door using the inner lock knob and open the door while the alarm system is in the set mode. Check if the alarm condition happens (horn sounds continuously, hazard light blinks, security indicator illuminates). Check if this condition lasts for a maximum of three minutes or until the "UNLOCK" button of the keyless transmitter is pressed.
NOTE: The alarm condition will cease in 30 seconds once the door is closed.
When none of above is applicable, perform troubleshooting for the security system.