Converter Case: Installation

Check the appearance of each component and clean them.
Press-fit the oil seal to the converter case using ST.
NOTE: Use a new oil seal.

ST 499587100 OIL SEAL INSTALLER

Fig 1: Pressing To Fit Oil Seal To Converter Case Using ST
Courtesy of SUBARU OF AMERICA, INC.
Install the front differential assembly and left and right side retainers to the case. Refer to INSTALLATION .
Remove the oil pump cover from the AT main case, and then adjust and check the backlash and tooth contact of the front differential. Refer to REMOVAL . Refer to ADJUSTMENT . Refer to ADJUSTMENT .
Apply proper amount of liquid gasket to the entire matching surface of converter case.
Liquid gasket:

THREE BOND 1215 (Part No. 004403007) or equivalent

Fig 2: Identifying Front Differential Assembly
Courtesy of SUBARU OF AMERICA, INC.
Install the converter case assembly without damaging bushing and oil seal.
NOTE: Use a new bolt for the oil charge pipe and ATF cooler pipe portions

Tightening torque:

Oil charge pipe and ATF cooler pipe portions

38 N.m (3.9 kgf-m, 28.0 ft-lb)

Other than above

41 N.m (4.2 kgf-m, 30.2 ft-lb)
Install the three converter case mounting bolts (TORX®).
Tightening torque:

41 N.m (4.2 kgf-m, 30.2 ft-lb)

ST 18676AA020 TORX® WRENCH

Fig 3: Removing Three Converter Case Mounting Bolts
Courtesy of SUBARU OF AMERICA, INC.
Apply proper amount of liquid gasket to the entire oil pan mating surface, and then install it.
Liquid gasket:

THREE BOND 1217B (Part No. K0877YA020) or equivalent

Tightening torque:

5 N.m (0.5 kgf-m, 3.7 ft-lb)

Fig 4: Identifying Oil Pan Mating Surface Liquid Gasket Applying Area
Courtesy of SUBARU OF AMERICA, INC.
Install the turbine speed sensor 1. Refer to INSTALLATION .
Install the ATF cooler pipe. Refer to INSTALLATION .
Install the transmission hanger COMPL.
Tightening torque:

41 N.m (4.2 kgf-m, 30.2 ft-lb)
Install the transmission harness connector to the stay.
Install the air breather hose. Refer to INSTALLATION .
Install the torque converter assembly. Refer to INSTALLATION .
Install the transmission assembly to the vehicle. Refer to INSTALLATION .