Front Vehicle Speed Sensor: Installation

Install the front vehicle speed sensor.
Tightening torque:

7 N.m (0.7 kgf-m, 5.2 ft-lb)

Fig 1: Identifying Front Vehicle Speed Sensor Securing Bolt
Courtesy of SUBARU OF AMERICA, INC.
Connect the front vehicle speed sensor connector.

Fig 2: Identifying Front Vehicle Speed Sensor Connector
Courtesy of SUBARU OF AMERICA, INC.
Apply proper amount of liquid gasket to the entire oil pan mating surface.
Liquid gasket:

THREE BOND 1217B (Part No. K0877YA020) or equivalent

Fig 3: Identifying Oil Pan Mating Surface Liquid Gasket Applying Area
Courtesy of SUBARU OF AMERICA, INC.
Install the oil pan by equally tightening the bolts.
Tightening torque:

5 N.m (0.5 kgf-m, 3.7 ft-lb)
Install the center differential carrier. Refer to INSTALLATION .
Install the extension case.
NOTE: Use a new gasket.

Tightening torque:

25 N.m (2.5 kgf-m, 18.4 ft-lb)

Fig 4: Identifying Extension Case
Courtesy of SUBARU OF AMERICA, INC.
Connect the rear vehicle speed sensor connector.

Fig 5: Identifying Rear Vehicle Speed Sensor Connector
Courtesy of SUBARU OF AMERICA, INC.
Install the transmission assembly to the vehicle. Refer to INSTALLATION .
Pour ATF from the oil charge pipe. Refer to AUTOMATIC TRANSMISSION FLUID .
Check the level and leaks of ATF. Refer to INSPECTION .