LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2013 >> Tribeca >> Repair and Diagnosis >> Brakes >> Traction Control >> Vehicle Dynamics Control System >> ABS Sequence Control >> Operation >> Abs Sequence Control With SUBARU Select Monitor
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Abs Sequence Control With SUBARU Select Monitor

NOTE: In the event of any trouble, the ABS sequence control will not operate.
  1. Connect the Subaru Select Monitor to data link connector under the driver's side instrument panel lower cover.
  2. Turn the ignition switch to ON.
  3. Run the "PC application for Subaru Select Monitor".
  4. Set the Subaru Select Monitor to "Brake Control System" mode.
  5. When the "Function Check Sequence" is selected, the "ABS Sequence Control" will start.
  6. Execute the following operations when the message "Press Brake Pedal Firmly" is displayed.
    1. When the brake tester is used, press brake pedal pad with a force of 1, 000 N (102 kgf, 225 lb).
    2. When using a pressure gauge, press the brake pedal so that the pressure gauge indicates 3, 500 kPa (36 kg/cm2 , 511 psi).
  7. "Press "OK"" will be displayed. Press the [OK] key.
  8. The brake system being operated is displayed on the Subaru Select Monitor.
scientia non olet · About LEMON Manuals