On The Car Wheel Balancing
CAUTION:
- Carry out this procedures after measuring the balance of each single tire.
- Set the vehicle so that the front and rear wheels are the same height.
- Release the parking brake during measurement.
- Rotate each wheel by hands, and make sure it rotates without dragging.
- Do not suddenly accelerate or decelerate while working.
- When an error is indicated during engine drive, do not use the motor drive together.
- Set the rigid rack to the specified locations of side sill, jack up the front or rear two wheels of non-measuring side and set the pickup stands to two wheels of measuring side.
- For drive wheel, drive the tires with engine for measurement.
- For non-drive wheel, drive the tires from the on the car wheel balancer for measurement.