Select Lever: Assembly

Clean all the parts before assembly.
Apply specified greases or equivalent to each part.
- Multemp AC-D or equivalent
  
  Fig 1: Identifying Grease Applying Areas (Multemp AC-D)
  Courtesy of SUBARU OF AMERICA, INC.
- Multemp SH-W or equivalent
  
  Fig 2: Identifying Grease Applying Areas (Multemp SH-W)
  Courtesy of SUBARU OF AMERICA, INC.
- Permalube BAN-5 or equivalent
  
  Fig 3: Identifying Grease Applying Areas (Permalube BAN-5)
  Courtesy of SUBARU OF AMERICA, INC.
Assemble in the reverse order of disassembly.
NOTE:
- Refer to "COMPONENT" for each tightening torque. < Ref. to AT SELECT LEVER , COMPONENT, General Description. >
- When pressing in the shift position pin, insert from the left side of the vehicle.
- Affix the harness of the shift button switch and the mode change switch at the marked positions.
  
  Fig 4: Identifying Shift Button Switch And Mode Change Switch Harness
  Courtesy of SUBARU OF AMERICA, INC.
- Connect the terminals of all switches to the respective connectors.
Fig 5: Connecting Terminals Of Switches To Connectors
Courtesy of SUBARU OF AMERICA, INC.
After completing installation, shift the select lever from the "P" range to the "D" range, then check whether or not the selection indicator in the combination meter and the select lever position matches. Also check whether the pointer and position mark matches, and what the operating force is.