LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2014 >> Tribeca >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls (Diagnostics) >> System Operation Check Mode >> Operation >> Notes
April 5, 2026: LEMON Manuals is launched! Read the announcement.

System Operation Check Mode: Operation: Notes

  1. Prepare the Subaru Select Monitor kit. Refer to PREPARATION TOOL , General Description.
    Fig 1: Identifying Subaru Select Monitor
    G05658482Courtesy of SUBARU OF AMERICA, INC.
  2. Prepare PC with Subaru Select Monitor installed.
  3. Connect the SDI (Subaru Diagnostic Interface) to the PC USB port (exclusively for Subaru Select Monitor) using a USB cable.
    NOTE: The dedicated port for the Subaru Select Monitor means the USB port which was used to install the Subaru Select Monitor.
  4. Connect the diagnosis cable to SDI.
  5. Connect the SDI to data link connector located in the lower portion of the instrument panel (on the driver's side).
    Fig 2: Locating Data Link Connector
    G05031666Courtesy of SUBARU OF AMERICA, INC.
    CAUTION: Do not connect the scan tools except for Subaru Select Monitor and generic scan tool.
  6. Start up the PC.
  7. Turn the ignition switch to ON (engine OFF), and run the "Application for Subaru Select Monitor".
  8. On the «Main Menu», select {Each System Check}.
  9. On the «System Selection Menu», select {Engine Control System}.
  10. Click the [OK] key after the information regarding engine type has been displayed.
  11. Select {System Operation Check Mode} on the «Engine Diagnosis» display screen.
  12. The following items are displayed on the monitor.
    Display
    Actuator ON/OFF Operation
    Immobilizer System
    Fuel Pump Control
    Fixed Idle Ignition Timing
    Idle Speed Control
    Injector Control
    EGR Valve Control
scientia non olet · About LEMON Manuals