System Operation Check Mode: Operation

CAUTION: After executing the system operation check mode, execute the Clear Memory Mode <Ref. to OPERATION , Clear Memory Mode.>.

Item

SSM display

Execution condition

Activating the actuator ON/OFF

Activating the fuel pump ON/OFF

Fuel Pump

ON ←→ OFF

Ignition switch is ON (engine OFF)

Activating the purge control solenoid valve ON/OFF

CPC Solenoid Valve

ON ←→ OFF

Activating the radiator fan relay ON/OFF

Radiator Fan Relay

ON ←→ OFF

Activating the ELCM switching valve ON/OFF

ELCM switching valve

ON ←→ OFF

Activating the ELCM vacuum pump ON/OFF

ELCM pump

ON ←→ OFF

Fuel pump control

Fuel pump OFF operation

OFF drive

OFF

At idling

Fixing the timing of idle ignition

Fixed Idle Ignition Timing

16.0°

At idling

Idle speed control

Idle Speed Control

500 - 2000 rpm

At idling

Injector control

Stopping fuel injection (Cylinder selection)

Injection Stop Mode

Injector 1
Injector 2
Injector 3
Injector 4

At idling

Fuel injection amount control
(All cylinders)

Injection Quantity Control

-13 - 20%

At idling

EGR control valve control

EGR Valve Control

0 - 255 STEP

At idling

Alternator control

Low mode
Middle mode
High mode
ExHigh mode

At idling

Active grille shutter control⁽¹⁾

Active Grille Shutter Control

Open
Close

Ignition switch is ON (engine OFF)
Experienced 20 seconds or more of the elapsed time after starting engine (when replacing ECM)

Compression measurement

Compression monitor

Ignition switch is ON (engine OFF)
Accelerator pedal is fully depressed

NOTE:

⁽¹⁾	After replacing ECM or active grille shutter, be sure to perform this procedure.

For detailed operation procedures, refer to "PC application help for Subaru Select Monitor".