1 CHECK COMMUNICATION OF SUBARU SELECT MONITOR.
- Turn the ignition switch to ON.
- Using the Subaru Select Monitor, check whether communication to all systems can be executed normally.
|
Is the system name displayed? |
Go to step 2. |
For diagnostic procedures, refer to the LAN article. <Ref. to
BASIC DIAGNOSTIC PROCEDURE
.> |
2 CHECK SHIFT LOCK.
- Turn the ignition switch to ON.
- Shift the select lever to "P" range.
|
While brake pedal is not depressed, is it possible to move the select lever from the "P" range to other ranges? |
Perform the inspection of "SELECT LEVER CANNOT BE LOCKED OR RELEASED". <Ref. to
SELECT LEVER CANNOT BE LOCKED OR RELEASED , INSPECTION, AT Shift Lock Control System.> |
Go to step 3. |
| 3 CHECK SHIFT LOCK. |
While brake pedal is depressed, is it possible to move the select lever from the "P" range to other ranges? |
Go to step 4. |
Perform the inspection of "SELECT LEVER CANNOT BE LOCKED OR RELEASED". <Ref. to
SELECT LEVER CANNOT BE LOCKED OR RELEASED , INSPECTION, AT Shift Lock Control System.> |
4 CHECK SHIFT LOCK.
Shift the select lever to "N" range. |
Is it possible to move the select lever from the "N" range to the "P" range? |
Go to step 5. |
Perform the inspection of "SELECT LEVER CANNOT BE LOCKED OR RELEASED". <Ref. to
SELECT LEVER CANNOT BE LOCKED OR RELEASED , INSPECTION, AT Shift Lock Control System.> |
5 CHECK SHIFT LOCK.
- Shift the select lever to "N" range.
- Turn the ignition switch to ACC.
|
While brake pedal is depressed, is it possible to move the select lever from the "N" range to the "P" range? |
Go to step 6. |
Perform the inspection of "SELECT LEVER CANNOT BE LOCKED OR RELEASED". <Ref. to
SELECT LEVER CANNOT BE LOCKED OR RELEASED , INSPECTION, AT Shift Lock Control System.> |
6 CHECK KEY INTERLOCK.
- Shift the select lever to other than "P" range.
- Turn the ignition switch to OFF.
|
Can the ignition key be removed? |
Perform the inspection of "KEY INTERLOCK CANNOT BE LOCKED OR RELEASED". <Ref. to
KEY INTERLOCK CANNOT BE LOCKED OR RELEASED , INSPECTION, AT Shift Lock Control System.> |
Go to step 7. |
7 CHECK KEY INTERLOCK.
Shift the select lever to "P" range. |
Can the ignition key be removed? |
AT shift lock system is normal. |
Perform the inspection of "KEY INTERLOCK CANNOT BE LOCKED OR RELEASED". <Ref. to
KEY INTERLOCK CANNOT BE LOCKED OR RELEASED , INSPECTION, AT Shift Lock Control System.> |