LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2015 >> WRX Base >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Anti-Theft System - Security And Locks >> Ignition Key Lock >> Replacement
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Ignition Key Lock: Replacement

CAUTION:
  • Before handling the airbag module, refer to "CAUTION" of "General Description" in "AIRBAG SYSTEM". <Ref. to CAUTION , General Description.>
  • Do not allow harness and connectors to interfere or get tangled up with other parts.
  • If the steering wheel and steering angle sensor (steering roll connector) are removed, perform "VDC sensor midpoint setting mode" of the VDC. <Ref. to VDC SENSOR MIDPOINT SETTING MODE , ADJUSTMENT, VDC Control Module and Hydraulic Control Unit (VDCCM & H/U).>
  1. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work. <Ref. to BATTERY , NOTE, Note.>
    NOTE: For models other than STI model, disconnect the ground terminal from battery sensor.
  2. Remove the column assembly - steering. <Ref. to REMOVAL , Steering Column.>
  3. Remove the ignition key lock.
    1. Secure the column assembly - steering in a vise.
    2. Use the reverse tap and drill to remove the set bolt and remove the ignition key lock.
  4. Install the ignition key lock.
    1. Secure the ignition key lock to the column assembly - steering.
    2. Use new set bolts. Tighten the bolt until the bolt head is broken (bolt head wrenched off).
      Fig 1: Locating Ignition Key Lock Set Bolt
      G08319257Courtesy of SUBARU OF AMERICA, INC.
  5. Install the column assembly - steering. <Ref. to INSTALLATION , Steering Column.>
  6. Connect the battery ground terminal. <Ref. to BATTERY , NOTE, Note.>
NOTE: For models other than STI model, connect the ground terminal to battery sensor.
scientia non olet · About LEMON Manuals