Steering Wheel: Installation
CAUTION:
- Before handling the airbag module, refer to "CAUTION" of "General Description" in "AIRBAG SYSTEM". <Ref. to CAUTION , General Description.>
- If the steering wheel has been removed, make sure that the steering roll connector is not turned from the original position.
- If the steering wheel and steering angle sensor are removed, perform "VDC sensor midpoint setting mode" of the VDC. <Ref. to VDC SENSOR MIDPOINT SETTING MODE , ADJUSTMENT, VDC Control Module and Hydraulic Control Unit (VDCCM & H/U).>
- Align the center position of the roll connector. <Ref. to ADJUSTMENT , Roll Connector.>
- Install the steering wheel.
Tightening torque:
Steering wheel: 39 N.m (4.0 kgf-m, 28.8 ft-lb)
Clearance:
Between cover assembly - column and steering wheel: 4 - 6 mm (0.16 - 0.24 in)
- Install the driver's airbag module. <Ref. to INSTALLATION , Driver's Airbag Module.>
- Connect the battery ground terminal. <Ref. to BATTERY , NOTE, Note.>
NOTE:
For models other than STI model, connect the ground terminal to battery sensor.