Engine Control Computer (Fa20): Installation
- Installation of engine control computer bracket
- Replace the bracket with a new one, engage 2 claws, and attach the engine control computer bracket to the engine control computer.CAUTION:
- After attaching the engine control computer bracket to the engine control computer, do not remove the engine control computer bracket.
- If the engine control computer bracket has been installed to the engine control computer in the wrong direction, replace the engine control computer bracket with a new one.
- Replace the bracket with a new one, engage 2 claws, and attach the engine control computer bracket to the engine control computer.
- Installation of engine control computerCAUTION: When replacing the engine control computer, do not use the one with a wrong specification.
- Using 2 nuts, install the engine control computer.
Standard value: T=7.5N.m {77kgf.cm} {5.5ft.lbf}
- Connect 4 connectors for engine control computer.
- Using 2 nuts, install the engine control computer.
- Installation of control module relay assembly (without smart entry) (Refer to KEY LOCK UNIT )
- Installation of glove compartment door assembly (Refer to INSTALLATION )
- Installation of instrument side panel RH (Refer to INSTALLATION )
- Connection of the battery ground terminal
Standard value: T=6.0N.m {61kgf.cm} {4.4ft.lbf}