Fuel Pressure Sensor (Fa20): Installation

1. Install the fuel delivery pipe (bank 1 side) with the two bolts.

   Standard value: T=19N.m {194kgf.cm} {14.0ft.lbf}

2. Temporarily install a new fuel pressure sensor to the fuel delivery pipe (bank 1 side) until it can be turned by hand.
3. Fuel the fuel pressure sensor.

   Standard value: T=58N.m {591kgf.cm} {42.8ft.lbf}

   CAUTION:

   • There must be no oil on the threaded portions of fuel pressure sensor and fuel delivery pipe (bank 1 side).
   • Do not allow foreign matter to get in when installing the fuel pressure sensor.
   • Do not retighten (or recheck the tightening torque of) the fuel pressure sensor after it is tightened once.
4. Connect the two fuel injector connectors and fuel pressure sensor connector.

1. Temporarily tighten the nut for new fuel delivery pipe until it is seated.
2. Temporarily install the fuel delivery pipe with the three bolts.
3. Tighten the three bolts.

   Standard value: T=6.4N.m {65kgf.cm} {4.7ft.lbf}

4. Tighten the fuel delivery pipe.

   Standard value: T=35N.m {357kgf.cm} {25.8ft.lbf}

(Refer to INSTALLATION )