LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2016 >> BRZ Series.HyperBlue >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System Diagnostics (3 Of 3) >> DTC P2530 Ignition SW Circuit >> Inspection steps
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Inspection steps

  1. Check ECM connector
    1. Check the connection of the ECM connector.

      Result

      Result Go to
      Not connected A
      Connected B

      B: Connect the connector properly.

      A: Go to next step

  2. Check ECM input voltage.
    1. Turn the ignition switch to ON.
    2. Measure the voltage between the ECM connector, chassis connector, and chassis ground, while wiggling the harness between the ECM connector and the ignition switch connector (for models without push start) or the harness between the ECM connector and IG relay 1 (for models with push start).
      Inspection terminals Inspection conditions Standard value
      A33-27 (IGSW) - chassis ground IG ON 8 V or more

      NG: Repair harness, connector, and switch.

      OK: System is normal. The circuit returns to normal at this point even if a DTC is detected.

scientia non olet · About LEMON Manuals