Pulsation Damper LH

Install the pulsation damper LH to the fuel injector pipe LH.
NOTE: Use a new gasket.

Tightening torque:

21.6 N.m (2.2 kgf-m, 15.9 ft-lb)

Fig 1: Locating Pulsation Damper LH
Courtesy of SUBARU OF AMERICA, INC.
Install the fuel pipe protector RH.
Tightening torque:

19 N.m (1.9 kgf-m, 14.0 ft-lb)

Fig 2: Locating Fuel Pipe Protector LH Bolts
Courtesy of SUBARU OF AMERICA, INC.
Connect the PCV hose.

Fig 3: Locating PCV Hose Clamp
Courtesy of SUBARU OF AMERICA, INC.
Install the clip (F) securing the generator cord to the fuel pipe protector LH.
Connect the connectors (C) and (D) to the A/C compressor and attach the generator cord to clip (E).
Connect the connector (A) and terminal (B) to the generator.
Tightening torque:

15 N.m (1.5 kgf-m, 11.1 ft-lb)

Fig 4: Identifying Generator Clip, Connector And Terminal
Courtesy of SUBARU OF AMERICA, INC.
Connect the ground terminal to battery sensor. < Ref. to BATTERY , NOTE, Repair Contents. >
Install the collector cover.