Section 12 (Engine Controls (H4DO) (Diagnostics - Introduction))
WARNING: This page is about a different variant/trim than selected.
- Basic Diagnostic Procedure
- Check List for Interview
- General Description
- Electrical Component Location
- Engine Control Module (ECM) I/O Signal
- Data Link Connector
- General Scan Tool
- Operation
- How To Use General Scan Tool
- Mode $01: (Current Powertrain Diagnostic Data)
- Mode $02 (Powertrain Freeze Frame Data)
- Mode $03 (Emission-Related Powertrain DTC)
- Mode $04 (Clear/Reset Emission-Related Diagnostic Information)
- Mode $06
- Mode $07
- Mode $08 (Request Control For On-Board System, Test, And Component)
- Mode $09
- Operation
- Subaru Select Monitor
- Read Diagnostic Trouble Code (DTC)
- Inspection Mode
- Drive Cycle
- Clear Memory Mode
- Active Test
- Malfunction Indicator Light
- Diagnostics for Engine Starting Failure
- List of Diagnostic Trouble Code (DTC)
- General Diagnostic Table